Saturday, April 26, 2014

Arduino Basics 6: Photo Resistor


Objective:
Using a photoresistor to control the brightness of an LED.

Parts:
Photo resistor
LED
10k ohm Resistor
330 ohms Resistor


Sketch:

const int sensorPin = 0;
const int ledPin = 9;
int lightLevel;
void setup()
{
  pinMode(ledPin, OUTPUT);
}
void loop()
{
  lightLevel = analogRead(sensorPin);
  Tune();
  analogWrite(ledPin, lightLevel);
}
void Tune()
{
  lightLevel = map(lightLevel, 400, 1023, 0, 255);
  lightLevel = constrain(lightLevel, 0, 255);
}


Analysis:
The LED[9] responds to how much light the sensor[0] receives. The sensorPin determines the LED’s brightness [lightLevel]. The function “Tune” tunes the number received through sensorPin so that it is only between 0 and 255 because analogWrite will only recognize values between those numbers.


No comments:

Post a Comment