Saturday, April 26, 2014

Arduino Basics 2: Potentiometer

Objective:
Control the LED's rate of blinking with a Potentiometer.

Parts:
LED
330 Ohm Resistor
Potentiometer



Sketch:

int sensorPin = 0;     
int ledPin = 13;
void setup()
{
  pinMode(ledPin, OUTPUT);
}

void loop() // this function runs repeatedly after setup() finishes
{
  int sensorValue;

  sensorValue = analogRead(sensorPin);    

  digitalWrite(ledPin, HIGH);     

  delay(sensorValue);             
  
  digitalWrite(ledPin, LOW);     

  delay(sensorValue);             
}


Analysis:
The LED [Connected to pin number 13, declared as "ledPin"] turns on [HIGH] for "sensorValue" seconds [delay(sensorValue)]. After that, it turns off [LOW] for "sensorValue" seconds [delay(sensorValue)].

"sensorValue" depends on how much you turn the potentiometer.



No comments:

Post a Comment